What Should I Pay Attention To When Using Explosion Proof Led Lighting Singapore?

1. Explosion proof led lighting singapore should pay attention to regularly cleaning the dust and dirt on the explosion proof led lighting singapore shell, keeping the shell clean, which can improve the light efficiency and heat dissipation performance of the explosion proof led lighting singapore. The cleaning method changes according to the protective ability of the explosion proof led lighting singapore shell. For example, the protection level of the explosion proof led lighting singapore is IP65, then we know that 6 is the dustproof level, which means to completely prevent dust from entering; 5 means the waterproof level, which means that it will be washed without any harm. Therefore, when we use water jet cleaning, we should cut off the power supply. It is strictly forbidden to use a dry cloth to scrub the plastic case (transparent) of the explosion proof led lighting singapore to prevent static electricity.

2. Check the transparent parts for signs of being impacted by foreign objects, and whether the protective net is loose, de-soldered, corroded, etc. If so, stop using it and replace it in time.

   3. If there is any water in the explosion proof fluorescent lighting singapore cavity of the lamp used in a humid environment, it should be removed in time, and the sealing parts should be replaced to ensure the protective performance of the shell. After the explosion proof fluorescent lighting singapore is shipped from the factory, during the final installation of the explosion proof fluorescent lighting singapore, the explosion proof fluorescent lighting singapore may also enter the water due to improper installation, causing the lamp to leak and cannot be used normally. Therefore, the installation method should also be proper to ensure the life of the explosion proof fluorescent lighting singapore.

    4. During the maintenance of the marine lighting singapore, the following points should be checked after opening the cover: 1. Whether the flameproof joint surface is intact 2. Whether the rubber seal is hardened or sticky 3. Whether the wire insulation is green and carbonized 4. Insulation and electrical Whether the component is deformed and scarred. If the above problem occurs, it should be repaired and replaced in time.

5. Before installing the marine lighting singapore, please check from the nameplate and the product manual: explosion-proof type, category, level, group; protection level of the shell; installation method and fastener requirements for installation. The installation of marine lighting singapore must be securely fixed, the fastening bolts must not be replaced arbitrarily, and the spring washers should be complete.

6. The sealing ring for dust-proof and waterproof should be installed as it is; the cable should be closely matched with the sealing gasket at the cable entry, the cross-section of the cable should be round, and the surface of the sheath should not have defects such as bumps. The excess inlet must be blocked according to the explosion-proof type, and the compression nut must be tightened to seal the inlet.

7. Check the transparent parts for signs of being impacted by foreign objects, and whether the protective net is loose, unsoldered, corroded, etc. If so, stop using it and replace it in time.

8.When opening the marine lighting singapore cover, open the cover after turning off the power according to the requirements of the warning sign.